D.A.S. variant series Instrucciones de operaciones descargar pdf (Pagina 17)

Manual del usuario/ User´s manual 38Variant series

4.6 SYSTEM INSTALLATION USING

THE CEILING SUPPORT AXC-V25

The VARIANT 25A units can be set up as a

long array of more than four enclosures (as explained

above) or as a small array of 2, 3 or 4 units. In the latter

case the highly resistant AX-V25grid accessory is not

necessary. Instead the AXC-V25 ceiling mount

accessory can be used to hang a cluster of up to four

units.

First attach the ceiling mount accessory to

the ceiling or a beam. Before doing so be sure that the

load bearing capability of these elements is enough.

The AX-V25will be attached to the ceiling by means of

sixnº 10 rawlplugs and six 7 x 40 mmscrews.

Before connecting the first box to the ceiling

mount accessory the two M8x30 DIN965 screws

must be removed from the VARIANT 25A and

replaced by two M8x35 DIN912.

M8X30 DIN965

AXC-V25

Three different washers must be used along

the M8x35DIN912 screws and placed in thefollowing

order-grower (lock) washer, metal washer and rubber

washer.

In order to hang the rest of the boxes the

captive rigging hardware and safety pins will be used,

and the procedures described on the 4.3 paragraph of

this manual will be followed. The picture below shows

three VARIANT25A units hangingfrom the ceiling.

Rubber washer

M8x35 DIN 912

Grower (lock) washer

Metal washer

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Sin comentarios

D.A.S. variant series Instrucciones de operaciones Pagina 17